13mm Socket
13mm Ring spanner
Reverse Torx socket E7
Parts
Manifold gasket
Studs x8
Washers x8
Nuts x8
To remove the manifold undo the 13mm nuts. You may find that some of the
studs come and on others the nuts will only come out. Remove the manifold.
To
remove the studs still left in the head, put two nuts on the stud, now tighten
the first one against the second. Undo the stud using the first nut.
Depending
on the type of stud being fitted you will either need to use two nuts lock
nutted against each other or you will need a Reverse Torx socket. Torque to 16Nm
for exhaust manifold or 19Nm for inlet manifold.
Now put you gasket on
followed by the manifold. Make sure you fit the washers, then torque the nuts to
6Nm
for exhaust manifold or 19Nm for inlet manifold.
Please note: The information on this site is a guide only, no liability can be accepted for any loss, damage or injury caused by errors / omissions on this site.
I won't be held responsible if you mess up yourself or your car.
In doubt always consult a qualified motor technician.
)
)
)